Universal Recloser Control Analyzer - GEN_I3V

The GEN-I3V is a universal recloser analyzer designed to test all types of recloser controls. It is designed to replace all old electronic recloser control testers. In addition to current injection it can inject 3 different voltages.

Connected to the appropriate interfaces (COOP-BOX, ABB-BOX, WEST-BOX), the GEN-I3V can test: Mc Graw-Edison, Cooper reclosers type F3, F4, F5, FXB, DC NOVA, as well as the ESV Westinghouse, Joslyn 351J, ABB PCD2000, Schweitzer SEL-351R or any equivalent.

The I3v is driven by a very powerful software, OpenZen I3V.

OpenZen I3V software is supplied with the equipment and all the upgrades are free.

Hardware

• Direct replacement of the K-MET universal analyzer that can test all types of recloser controls
• Direct connections to all recloser controls via interfaces
• Insensitive to noise and high voltage transients
• USB communication link

OpenZen I3V:

• Automated tests reports
• Full control over current injection and voltage forms
• Automatic point positioning on graphics
• Simulate various faults of power lines
• Minimum Trip detection
• Reclosing interval measurement
• Reset time (Rearm delay)

Hardware

• 1 current output (software programmable by frequency, phase and amplitude)
    * Amplitude of the Injected Current : 14 amp RMS by step of 4 mA
    * Frequency Range : 0 to 10 kHz
    * Frequency resolution : 0.004 Hz
    * Phase shift: 0 to 360 degrees by steps of 0.09 degrees
• 3 voltage outputs (software programmable individually in frequency, phase and amplitude)
    * Voltage range: 0 to 200V peak to peak by step of 50 mV peak
    * Signal forms: sinusoidal, triangular, square or DC
    * Frequency Range : 0 to 10 kHz
    * Frequency resolution: 0.004 Hz
    * Phase shift : 0 to 360 degrees by steps of 0.09 degrees
• USB high speed link
• Amphenol connector

Software

• Signal form controlled and set by software
• Recording length : 1 millisecond to 17 minutes.
• Sampling time : 6 microsecond to 32 000 microsecond
• Comply to international standards ANSI C-37-60 and IEEE Std 321-1973